Wheel Fitment & Question Thread
- Thread starter BorHor
- Start date
does center bore matter? can i just pick any center bore or does it have to be the right size?..whats the c/b for the supra?
any body know where what tire still produces white raised letter tires to fit oem rim 225/50/16?
Question about tire pressure, probably the best thread for it 
: Anyone have experience with 235/40/18 and 265/35/18 ? About how much would be needed to get even wear?
: Anyone have experience with 235/40/18 and 265/35/18 ? About how much would be needed to get even wear?
I plan on replacing my sawblades with my tax return. I was thinking about going with 18s but I was wondering what's the widest i can go without having to roll my fenders. I was also thinking about a stretching the tire a lil bit. You can say I was inspired by Borhor. Lol.
It isn't going to work with out rolling. I would say safest is 18x9.5 +35 with a 275/35/18 tire for the rear. Fronts depend on if you want to go staggered or not.
Do you think the 18x9.5 +35 offset with a 275/35/18 tire would fit up front without rolling or pulling? Looking to go as big as I can up front and match it in the rear. Lowered on H&R springs if that helps any...
You will not be able to run that much tire on the front with that rim. It will fit perfectly on the rear, but you will need to stretch it to fit the front. Not sure since this is more Borhor's area, but I think you would have to run a 245 to not rub. Wait for him to confirm though.
jackal613;1250937 said:
it has been done i know of two ppl with the same exact setup, however there not on h&r springs, one is one stock and the other is on eibachs i believe, I doubt that ull be able to do it on h&r's since the drop is so low.
It can probably clear with a fender roll. If anything it will be rubbing on the inside. I had a 9.5 +15 in front with a 245 RE01R so it was fat and I didn't rub on the fender with a roll and pull though.