Installing the AEM ecu and a TH350 there are now going to be extra connectors and wires.
What is the recommended method of handling these? Would it be to cut and cap each wire, relocate them and tie them up out of the way and out of site? I just don't want it cluttered with all the plugs. I wish I knew EVERYTHING I could remove by going with the AEM and a TH350. I want it to be clean under the hood.
What is the recommended method of handling these? Would it be to cut and cap each wire, relocate them and tie them up out of the way and out of site? I just don't want it cluttered with all the plugs. I wish I knew EVERYTHING I could remove by going with the AEM and a TH350. I want it to be clean under the hood.