SAFC 2 to AEM V2

[mensrea]

Switching from SAFC 2 to AEM V2 (PNP), removed/fixed most of the wires. Engine cranks, but does not start.
I have one wire left, coming out of the harness, its blue with pink stripe, it does not seem to go no where, white wire from SAFC 2 was connected to it earlier. Is that a MAP signal ? what do I connect it to ?
I tried searching here as well as google, no luck so far.

 

[justin.daniels2]

http://92tealsupra.m.webs.com

Go to more options, scroll to jza70, 1st wire on the list for plug "x" says HT oxygen sensor heater

 

[mensrea]

I got it figured out, Thanks !
Now need to set/sync the timing. What timing light ya'll use on 1j ?