I went to get an alignment the other day because its wayyy off,
They couldn't do the front or the back..
Front could not be done because the lower ball joints were shot and allowed too much play ( I bought replacements from driftmotion)
Back could not be aligned either because the lil thingy that hugs the adjustment washer is bent back as shown here :
http://s6.photobucket.com/albums/y230/thesnowboarder/?action=view¤t=DSC00001-8.jpg
and here kinda too
http://s6.photobucket.com/albums/y230/thesnowboarder/?action=view¤t=DSC00002-7.jpg
My question:
What can I do to remedy this? Aaron from DM suggested hammering it back and welding it in the crease has anyone tried that?
They couldn't do the front or the back..
Front could not be done because the lower ball joints were shot and allowed too much play ( I bought replacements from driftmotion)
Back could not be aligned either because the lil thingy that hugs the adjustment washer is bent back as shown here :
http://s6.photobucket.com/albums/y230/thesnowboarder/?action=view¤t=DSC00001-8.jpg
and here kinda too
http://s6.photobucket.com/albums/y230/thesnowboarder/?action=view¤t=DSC00002-7.jpg
My question:
What can I do to remedy this? Aaron from DM suggested hammering it back and welding it in the crease has anyone tried that?