Hey everybody was wondering if somebody could me out I just finished installing my engine in the engine bay I rebuilt a 7mgte new pistons, bearings, gaskets and valves etc. i plug everything back except the air hoses and turbo filter,I haven't plug the throttle position sensor. When I crank the engine it wont start. I checked for current and theirs current from battery to distributor to coils to plugs but not into the engine bay or spark plugs plus it has a new alternator.
no spark in the plugs car wont start
- Thread starter jdm76nyc
- Start date
Make sure all the wire harness plugs are connected. Coil plugs, igniter, all the plugs on top of the motors.
Make sure you got the grounds put on the motor, the one near the back of the exhaust and the two eyelets on the intake.
no afm realized how important i need it looking to get one if u now who has one extra let me know the one i had is no good
---------- Post added at 01:35 AM ---------- Previous post was at 01:34 AM ----------
back of exhaust and two eyelets ? little loss here..
---------- Post added at 01:35 AM ---------- Previous post was at 01:34 AM ----------
back of exhaust and two eyelets ? little loss here..
