Yes I searched in the MAFT-Pro sub section already.
I know v5.03 of Maft-PRO allows you to change the RPM & MAP axis points. However when I changed them in the BIN/front-end it simply changed the label on the VE Table in TunerPro RT. Even after turning off & re-enabling ALDL Tracing, the same cells were being highlighted, so it appears editing the values from the BIN/front-end/double clicking on them didn't work for me. I did some research and discovered that it seems the XDF Files need to be edited. I tried to select the MAP Axis, then F2 to Edit XDF Item, however it's grayed out and I can't change it.
I want to get rid of the 7600 rpm column and add one @ 3100rpm. And I'm going to nix the 280, 300, & 320 kpa rows on the MAP axis so I can add a 30kpa, 47kpa, and 54kpa rows. Basically I want to shift the axis' so that I have more points of control right around where I'm cruising. I have an annoying lean out on partial-throttle cruise when off load. (gets to around 15.5 to 16.5 AFR).
I can post BIN, ADL, ADS, XDF etc. if needed, however simply getting these changes made to the axis is all I need.
Thanks in advance,
Rusty.
I know v5.03 of Maft-PRO allows you to change the RPM & MAP axis points. However when I changed them in the BIN/front-end it simply changed the label on the VE Table in TunerPro RT. Even after turning off & re-enabling ALDL Tracing, the same cells were being highlighted, so it appears editing the values from the BIN/front-end/double clicking on them didn't work for me. I did some research and discovered that it seems the XDF Files need to be edited. I tried to select the MAP Axis, then F2 to Edit XDF Item, however it's grayed out and I can't change it.
I want to get rid of the 7600 rpm column and add one @ 3100rpm. And I'm going to nix the 280, 300, & 320 kpa rows on the MAP axis so I can add a 30kpa, 47kpa, and 54kpa rows. Basically I want to shift the axis' so that I have more points of control right around where I'm cruising. I have an annoying lean out on partial-throttle cruise when off load. (gets to around 15.5 to 16.5 AFR).
I can post BIN, ADL, ADS, XDF etc. if needed, however simply getting these changes made to the axis is all I need.
Thanks in advance,
Rusty.