morganson's COP S-Type setup
- Thread starter morganson
- Start date
OK, need to sort through the group here.
Shipped today was Grimreaper, Reydio, and Lithium14. Im so time crunched after work I forget about my quote to canada I need, I will get that tomorrow when shipping the rest of these.
Shipped today was Grimreaper, Reydio, and Lithium14. Im so time crunched after work I forget about my quote to canada I need, I will get that tomorrow when shipping the rest of these.
and to answer your second question i do make the harness. If you are interested i can do it with the factory plug or a four pi. Weatherpack if you are not afraid of repining your harness. The latter is how mine is set up currently. PM me and i can get you more information.gs2040215;1986876 said:
Mine came in today. The quality of the cuts are immaculate. I'll be mounting my coils on it here in a few. Just a quick and probably dumb question. How exactly does this mount to the head?
BryanDyer;1986933 said:
Its fine, I just thought I would ask to get a quicker respond instead of looking through the all 41 pages. My apologies to, I don't really come to forums to try to fight anybody. and its in the 11th page, post 110... For anyone else who might have the same question as me.
Scooter7M;1986984 said:
I think the plan (Im not 100%) is the end user welds a bolt into the center hex section and uses it as a stud. I had asked a while back if anyone could give me a bolt length and I could supply that too, but never heard.
Sorry ill get a measurment tomorrow. I am using two threaded galley plugs and a pair of 3/8 studs. The plate was designed with this in mind and already has holes drilled for that.