knife edging intake port divider, did I screw up?

[Tire Shredder]

I'm taking a break, have been porting my head.

seemed to make sense to knife-edge the port divider on the intake side.

I started knife edging the divider for the intake port and just read this....

it suggests I shouldn't have done it....now what!?! ahhh help!

http://users.tpg.com.au/users/loats/index.html

 

[IJ.]

Personally I'd radius them.

 

[Tire Shredder]

you think some flat, blunt area is necessary? I'd say I have it 50% done, there is still a flat section roughly 3mm wide. I could leave it. Can you elaborate IJ?

P5150's write up suggests knife edging it.
http://www.supramania.com/forums/showthread.php?t=34310&highlight=port

 

[IJ.]

Radius as in make the edge curved

 

[figgie]

you think some flat, blunt area is necessary? I'd say I have it 50% done, there is still a flat section roughly 3mm wide. I could leave it. Can you elaborate IJ?

P5150's write up suggests knife edging it.
http://www.supramania.com/forums/showthread.php?t=34310&highlight=port

no

knife edging will introduce a sharp edge that if not perfectly straight will divert air to one side more than the other. Radiusing takes care of that.

 

[TurboStreetCar]

hmm, good information here.