is .006 out of specs??

[88mk|||]

Im a novice to this, my cylinder bore is .020 over stock which i believe stock is 3.267 and i should be 3.287. my worst cylinder #1 is 3.293 at the top so i have a differance of .006 here. I guess im looking to go .030 over now?

 

[88mk|||]

So, the TSRM I found a o/s which should be for a .020 bore and it's says limit 3.296 an the worst cylinder is #1 which is 3.293 at the top. So I'm good? I think/hope..... I really don't care to re bore it to .030 but if it's still good than why bother.

 

[88mk|||]

Oh ya on cyl #1 I measured the piston and I came up with a .009 piston to wall clearance. I might have to take another measurement cause I was kinda in a rush, had to leave for work.