Does anyone know the specs of the bolts (length, thread spacing, etc.) used to fasten the fan clutch to the water pump pulley? Also, I need to know the specs for the nuts used to attach the fan to the fan clutch. Thanks!
Fan clutch hardware
- Thread starter swaq
- Start date
I am a long way from my car, but would be suprised if it wasn't 8 x 1.25. From memory, the wrench is 12, making the stud 8. Very typical Toyota, most are the same.
Hmm, looking at the EPC it looks like it's more like a stud:
http://www.cygnusx1.net/Supra/Library/EPC/291210/catalog.aspx?F=1601&P=1
The shop that last replaced my water pump just used bolts to connect the pulley to the water pump. I had electric fans so there was no fluid coupling. Looks like I'll be ordering more little bits and pieces again.... :3d_frown:
http://www.cygnusx1.net/Supra/Library/EPC/291210/catalog.aspx?F=1601&P=1
The shop that last replaced my water pump just used bolts to connect the pulley to the water pump. I had electric fans so there was no fluid coupling. Looks like I'll be ordering more little bits and pieces again.... :3d_frown: