Electric speedo solution?

[T34418L3ONE]

for those looking to replace they're stock speedo, check this out. http://www.marlincrawler.com/htm/transfercase/tcase_ac.htm

if you look it converts the cable to a VSS signal compatible with electric speedos. Well at least i think itll work. What do you guys think? Marlin is the man when it comes to toyota 4x4 world, and some of his parts even work on the supra!

 

[hottscennessey]

Yup, I think it will work.. I was looking for this! We just need to find out which electronic speedos they will work with. 3 wire 4 pulse? hmm.

 

[mkIIIman089]

Looks like it should work to me. Where can you get the other end of that connector though?

 

[T34418L3ONE]

hmmmm i think marlin should be able to source the pigtail

 

[Jeff Lange]

90980-11143 = Connector Housing
82998-12440 = Connector Splices (3 required)

 

[T34418L3ONE]

sweet

 

[crazysupra2JZ]

you think it would work for TEMS too. cause it uses an electric signal to determine when to switch over to a firmer setting at higher speeds

 

[mkIIIman089]

(3 required)

I assume that would be 12V, ground, and a signal wire correct?

 

[T34418L3ONE]

sounds like a typical 3wire sensor to me!

 

[hottscennessey]

I wish I could find an electric gauge that would look decent in our cluster, I'm sick of replacing the speedo cable.