I bought a head off of a member here had a lot of money out into the head 3 angle valve job. Street port and polish,springs tested, new valve stems, all new gaskets, and pressure tested
It was decked 10 thousands he ran it for 8,000 miles and blew a bearing so I bought it off him
This is how it looks now after I put done brake clean and scotch brite http://img.tapatalk.com/d/14/02/26/u6yry6u6.jpg[/IMG
The head looks good can still clearly see the mill markings, if I hAve to get it decked again just to be sure I will but what is your guys opinion on what to do. It is flat though
It was decked 10 thousands he ran it for 8,000 miles and blew a bearing so I bought it off him
This is how it looks now after I put done brake clean and scotch brite http://img.tapatalk.com/d/14/02/26/u6yry6u6.jpg[/IMG
The head looks good can still clearly see the mill markings, if I hAve to get it decked again just to be sure I will but what is your guys opinion on what to do. It is flat though
