has anybody used the bic mounts on a soarer 1jz? i was pretty sure the mounts were the same on either, the website does not specify a supra 1jz. The mounts are totally off and now i'm not sure which goes on what side, because apparently the soarer motor has the same bolt patter on both sides. If anybody could give input on this it would be great, i'm about to just customize the mounts myself.
bic mounts wtf
- Thread starter Ds650rida
- Start date
drivers side
you have to change which bolt holes you use, you have to unbolt the fuel pulsation dampner and use those bolt holes for the rear of the mount, then you have to have the bolts go through the dampner, mount, and then into the block, i can take a pic tomorrow when i get my car back for you if you want
pass side shouldnt have any problems
you have to change which bolt holes you use, you have to unbolt the fuel pulsation dampner and use those bolt holes for the rear of the mount, then you have to have the bolts go through the dampner, mount, and then into the block, i can take a pic tomorrow when i get my car back for you if you want
pass side shouldnt have any problems
wow that would be great.
so your saying that i have to use different holes in the block than the ones for the mount? is your 1j from a soarer?
so your saying that i have to use different holes in the block than the ones for the mount? is your 1j from a soarer?
okay great, i was seriously about to hack up the mount and start welding pieces on, i'll try that, thanks a lot!