I was parked outside work on a public street. Guy hit me, i heard the noise went outside and seen him slow down then speed away. It was like an old prelude or somthing. He fucked his car up. I work like 1500ft from the turnpike entrance so he got on and was out. I didn't get a plate number...
I fucking hate cock suckers that do shit like this. I hope he rots in fucking hell. Dude was driving a honda of some sort doing like 35 hit me and bounced fucked my bumper up. Not the supra my DD blazer.
I suggest getting components for the front put the 4'' in the door and mount the tweeters on the dash. Like they said no rears are needed maybe a 10 in sub in the back that will make it sound great.
Brian
should i run 4 gauge from each amp, or could i run another dist block for the grounding and run the 10 gauge into that.
When removing rca's from deck i still have int, this means that it is either ground loop or rca interference correct
Thanks
Brian
They cross by the amps where i had to run the power wire to the amp and and the rca's to the amp. When i disconnect the rca's from the amp they go away but havne't disconnected from the deck yet will do tomorrow.
Thanks
ok,
Ground wire is 10 gauge
WHen i rev the engine i do not hear it, I do not believe it is alternator whine. The engine covers the sound.
It went away this morning but came back this afternoon.
The sound is coming through the sub as well.
Could it be caused by the rca's passing by the...
Ok so i wired up my whole system and can't figure out where i'm getting the interference from.
Front Components are Infinity References going to Crossover then to Rockford Punch amp
Rear Speakers are Polk Audio going to another Rockford Punch
Subs are Kickers going to hifonics amp...
well... I am currently selling a ppi as i mentioned in my post.
Check this out...
http://www.supramania.com/forums/showthread.php?t=46160
Sorry for plugging my for sale post but i think it will help.
PM me if you have any questions.
Brian
Bro take that pipe off bring it to autozone on 30th and see what they have that you can match it with a metla pipe even if you have to cut it up alittle bit, so what. it will work may not be the best looking ic pipes but if that was what you wanted you would just buy a complete hard pipe kit...
Do not ever use them. I was on the parkway and my radio cut out so i pulled over and took them all off used a lighter to strip the wire and electrical tape to put it back to gether and it worked better then with the quick connects/splicers.
Brian
Ok 2 months later and everything is resolved. I must compliment myself on creating the absolute worst ground from the head unit ever available. Second installed my refernces up front. Ran a better power wire and everything runs perfectly.
Thanks for all the input
Brian
Great idea, an older amp maybe idk a PPI Art A404. would compliment this setup nicely. get nice clean power out of that type of amp.
Just shooting some ideas to you
Brian
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.