Search results

Kewl car.

Check out driven2modify its a local board. I'm in Pensacola there are a few good one here. Not sure another PC.

Yes 440 with a resistor pack wired in sorry forgot that. Thanks alot ycode1990at g mail.

Stock 7mgte running on Cressida electronics. Afpr, wideband. 3"elbow and 3" straight pipe that's it. 5speed.

hooked up the mapecu on my 89 Cressida . Does anyone have a good starting point to get me going. I've got it idling and off boost it does ok . But I need help.

Haven't been on for a bit. The car is running pretty good . The VPC wouldn't work with the 7mgte rom because of the different AFM's . I'm looking at map ecu now . I may have found one on the cheap . ohh yea I fixed the AC.

Good point lol. It runs great with the additional fuel for sure -32% at 1000 rpm lol. I can tell low speed is gonna be hardest to nail down. What ne points do you guys setup on the safc for these motors? Also throttle point?

So the 7mgte rom chip should do?

720cc injectors installed. Running rich now. SAFC can get me close. So I won an HKS VPC on E-bay will this work with my GE electronics? I'd really like to keep the GE electronics because the sensors are cheaper and I like the distributor and the freedom of upgrading that goes with it. I know DIS...

I looked at them the shape looked right and they are green ish. Ahhh at least I have some big-uns.

I wasn't sure how to tell them apart. Guess that explains alot.

High impendence injectors. I have some low imp.720's guess I'll be building a resistor pack tomorrow day I got it looks a bit different now.

I'm fairly new to Toyotas. A few months ago I bought a 91' Cressida. The PO swapped in a 7mgte, r154 and LSD from an MKIII. The motor is pre 89'. Here's my issue it has the Cressida wiring harness, distributor, AFM, and O2 sensor. The first thing I did after I got it home was install an AEM WB...

Nice. There's an 85 rotting away about 4 miles from me . Dude won't sell it.

Gonna go clean my shorts now. Love the project.

NO^!

What did this "Shim" look like? I've never heard of a HG shim ever.

I saw a write up while doing research.

Tin-snips FTW! Every EFI car with an in-tank pump I've ever owned got an access panel. Be careful drilling your pilot hole Use a step bit 1 ring at a time so you don't go to deep. Then use snips (you wont cut anything but the sheetmetal or make any sparks). A hand brake and hammer/dolly will...

About 15k lol.