Search results

  1. G

    Koni front adj shocks. No spring seat

    I recently got a set of adj Koni front shocks, They don't come with the lower spring seat on the shock. You are supposed to use the factory seat. I looked in the electronic catalogs and can't find any spring seat for the front shock. Looks like it's made on the shock. Wouldn't be such a problem...
  2. G

    Greddy e-manage ultimate or micro/megasquirt

    Looking at doing one of these on my 1jzgte swapped car. Any one seen any information on the microsquirt or megasquirt being installed. I think the issue lies in the ign/coil packs. Also any one had any luck with the e-manage units. I'm not going to go too crazy with this car. stock...
  3. G

    To piggyback or not.

    I have a 1jzgte in my 86.5 mkIII and I want to be able to tune for timing and fuel. Also want to be able to tune for single turbo when the time comes but mainly I just want to be able to tune for the stock twins and the usual add on stuff i.e. injectors, more boost tune for water/meth injection...
  4. G

    MAP sensor line

    I have been going over my new 1jzgte Supra and I noticed the map sensor line came off of the manifold from a small round check valve looking screw in fitting. and above it is a normal vacuum fitting. I've been looking everywhere and cant find out what the screw in fitting is and if the map...
  5. G

    Started the build of my first Supra

    Started building her. Replaced the wheels with 18" bbs style wheels. Replaced the springs with H&R race springs. Replacing all the rear bushings this weekend. Rear toe rod bushings on the rear knuckle are shot. I get a lot or rear toe changes when accell and decell. I think I'll replace all the...
  6. G

    boost level with 1 turbo out/bad

    Any one remember what there boost level was with 1 turbo out or going out. I need to double check but I think mine is maxing out at 7 psi/.5kpa I know I'm asking a lot of questions but bear with me till I learn the little in's and out's with this motor.
  7. G

    1jzgte oil pressure

    I'm trying to determine if I have a problem or not with my oil pressure. I have good pressure when at idle. 20 psi but when the car is at 3k or more the pressure appears to go no higher than 40-50 psi. This is all on the in dash gauge. I will have to put my mechanical gauge on it to confirm...
  8. G

    Buying my first MKIII 1jzgte car

    Going down to Fl to buy my MKIII today. Anything I should look for or be aware of on these cars. Can't wait to drive her back I have always liked the MkIII. Wish it was a 2jz car but that can always be done later.