is it possible to check the crank trigger through the hole where the crank sensor goes? maybe wiggle with a small screwdriver ? or does the crank pulley need to come off ?
yes part of the shielding, and believe me im exhausted all out of ideas
by any chance do u know exactly how the cams sensors and crank work in correlation to adjust timing ? and what exactly is happening when i run it with both sensors off that it pulls strong throughout the rpm range, my...
good thread , after reading that a crank sensor can ohm out fine but still be bad i went ahead and pulled my known working one out of the supra which is the only sensor i haven't changed(only changed both cams sensors) upon closer inspection now under daylight i see that the ground (black wire)...
hmm i understand although i highly doubt it these wiring specialty guys have a good rep wiring is all new mil spec wiring, one question would what i did rule out the harness for example i read the resistance on the cam sensor on the ACTUAL sensor came up 1132 for the front sensor then i traced...
hello forum i have quite the problem and im stumped ive tried everything to my knowledge , i come to seek help as i skim these forums and theres alot of knowledge here, ok so here the problem , i got a 1jz in a s13 240 single turbo, car runs great but when i get on wot u feel the ecu pulling...
Thanks for the reply . . .Its not the coils I thot they were bad as mostbof the topics of a misfire while entering boost were cracked coils . I checked them boots off and were fine I put new ngk coppers gapped correctly 28 and the funny thing is ive done a couple pulls to redline without it...
Hi guys hope all is well . .I rarely get on here but I have a problem with my CEL on my car . . .ive read about cel problem on other threads but all seem to not work . .mine is on but wen I trip the diagnostic box to read the codes it wont read them it doesnt blink just stays on . .I really want...
Yea they thought harder on the 90+ supras, I was working on one the other day and noticed the little bent pipe has a cooler integrated into it, I guess they notice the bend pipe kind of a dumb idea
No my car was an original 5sp na. . .what i dont get is y my mph are acting as rpm. .ill try and get a vid tomorrow so u see what i mean. . .has anyone else experiance this
Sent from my SAMSUNG-SGH-I717 using Tapatalk 2
Hey guys i have a question i cant seem to find the answer to. I did my 1j swap on my na chassis its an 89 my 1j is from a soarer but i put a jza70 harness and ecu . My problem is my rpms dont work,when i start.the engine my mph guage goes up and sits at like 20mph on idle and as i rev it goes up...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.