Search results

Not sure, the tacho isn't connected yet. I'm guessing around the 1400 mark, it drops down once its warm though. I still haven't wired up everything though, I've been adressing other issues. I have to sort everything out then I'll worry about how it runs.

4th July Bunnings carpark Woodville (opposite CMI) Roll up at 4pm No drags No wheelies No skids No DH driving This is a cruise not a race Observe the speed limits and have fun Directions will be availiable on the day. If you want them now, send me a PM with your email address

Maybe, I'll check it out. It doesn't get that cold here in South Australia so I'll probably disconnect it.

Theres a yellow wire coming from the 22 pin ECU side that was conected to the same wire on the Cressida loom, I cut that and its fine. Now it runs for about 10 seconds when cold then starts to spluttler and wants to stall but it'll start to idle normally after. It does this twice and once its...

Hhmmm...I'll check that tomorrow morning. I used a few different diagrams.

I've put a 7MGTE into my MX83 and the conversion is nearly complete. The problem I'm having now is, it starts and runs for 2 seconds then dies. Its coming up with an error code of 31 I've checked the conections, wiring and tried a 1UZ AFM to no success. The motor was in a MA61 before...