First let me apologize for re-posting. I attempted to read other threads on this issue but I am just not understanding. (Yay he can search now) I had a JDM swap 7mge. HG blew after 800 miles. The guy followed all data instead on listening to what i said about the forums of over-torquing...
The sensor on my 87na is brown wire. Yellow connectors. It should be noted that when hooking my fuel injectors back up there were some serious differences in what the wire colors were supposed to be and what they actually were. So, my colors may be off due to terrible re-wiring. The Haynes...
I would recommend doing headers back. Prior to my engine replacement it only had the flowmaster with stock headers. While doing the swap the pacesetters were added. I think it sounds much much better. Buuuuut it all depends on what you're looking for in terms of sound and performance. I...
Need coolant overflow tank and sensor 87NA. Most important is the rubber grommet holding the sensor in the res. Ill buy now. Send me paypal. 937 533 3011 thanks!
I had already thought of that. Problem with that is, it voids most headers warranties. I guess I could give a shot since I already had to shave part of the flange on the headers to go around the water pump.
:1zhelp:My accordion hose intake was mangled when I purchased my 87. I just had the engine swapped with another 7mge. I added pacesetter headers, and the stupid universal flex intake hose (soon to be replaced). The stock exhaust manifold heat shield didn't come close to fitting. What I want...
I have looked online and have checked with aftermarket parts places such as auto zone and advanced auto and even napa auto parts. I am looking to upgrade the alternator so I can prevent having to run a battery in the "trunk" area. No one had a higher amperage alt. that would fit. According to...
As stated in my introduction this is my first forum. I am astounded at how much information I have gotten in just a few short days. Thank you again for this great idea! Damn I hope I can contribute something useful at one point or another. HAHA
Blah new solution! New optima red top new alternator and a professional install. The jackass I bought this car off of installed this head unit himself. As I pulled the unit out of the bracket it grounded itself out on exposed power wires. So Im going with a new headd unit as well... Haven't...
I was unaware the 501's would fit the fronts as well. Does crutchfields provided bracket make that possible or does it require modification? My plan will be a set of PA components I will put the tweeter in the pillar I think. I think the 2 ways in the rear would be alright but the components...
Ok thanks I guess I'll try to learn I was more or less giving funkey monkey a hard time since he appeared to be doing the same for me. =)
No hard feelings monkey.... honestly though I am horrible at geometry!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.