So, I ordered three 2SD2162's through www.utsource.net and have received them. I've installed them and the ecu works fine again :)
@ Evil, yes, they drive the injectors and I can't remember what exactly I did wrong. It had to do with the wiring. It was a couple of years ago just before I went...
So I tried the TIP122's today. The car started and ran for a few seconds but died because it went pig rich. Tried it a couple of times; same result. (I do have a working Blitz ecu which is normally used in the car, just to be clear on this.)
It is a step forward as before the car wouldn't even...
Now that you mention it, yes, I think you're right.
I purchased the TIP122's today as these were the only ones the local radio shop had. The NEC's were quite hard to get hold of over here (The Netherlands) the guy said.
Hi,
This is from a Blitz 1jz ecu. The three circled thyristors need replacement, they are part of the injection. The problem is that because they are fried I cannot measure what they should be to get replacements.
The numbers on them (NEC D2162 K 08) don't give me anything on the web, I've only...
These are some upskirt pics of my supra, I hope they're elite enough. :)
After some years of trial and error it is now fully circuit-proof. Amongst other improvements to make it circuit-proof I've installed heat plates and quite a bit of heat wrapping. Btw, it's a 1.5jz
actually, the ngk 3330, which is the BCPR7ES is one step warmer from the plugs I use now (BCR8ES)
the number in the ngk part# tells you the heat range; the higher the colder
Thanks for the replies guys, much appreciated. I'll lower the gaps first to see if that improves things. Thinking about purchasing a spark amplifier as well.
btw, meanwhile continued searching and found the ngk 2669 (BKR9EIX) I read they use them in high powered supra's (2jz) with succes.
I'm running NGK BCR8ES plugs, but I would like to go one step colder because I'm suffering from some spark-knock/pre-ignition and want to try to see if I can cure it with a colder plug.
However, the BCR9ES does not exist, the '8' is the coldest for that plug-type. I like that type of plug...
I wanted to do a brake fluid change as I have done many times before on my supra (and other cars). Because I had been working on the car mostly last few years in stead of driving it I hadn't done a change for a few years and the times I did drive it was on the tracks, so I decided to let all the...
In case you're doubting between a 1jzgte and 2jzgte stock headgasket, i did a comparison last year:
http://www.supramania.com/forums/showthread.php?t=47831
stock - bpu > IK22
higher boost > IK24
i personally have bad experience with iridiums, the electrode broke off from 3 plugs and damaged head, valves and pistons
i've also seen another engine having this same problem
the electrode on a copper plug is much stronger, they perform better up to...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.