Recent content by paulmicin

you lurking slut

I hope these can help http://s27.photobucket.com/albums/c197/paulmicin/Turbo%20Supra/

Also, what are the odds there was an damage to the turbo with no cooling and all. i never pushed it hard for more than a few seconds.

That's some crazy shit. I mean why would someone put rtv there because i dont think that could have gathered there by itself, right? You're talking about the braided pcv hose, right? Yea, they helped thanks dude.

Ok, so i removed the coolant lower return line with the banjo bolt and look what i found!

is it supposed to be free flowing enough to where i can blow through it with my mouth, because now i can not do that at all.

hey guys, so went to replace my coolant feed line for my turbo ( the rubber part) because it was hard and brittle, so i installed a clear hose. as it was warming up and got to full operating temp i noticed no coolant flowing through. At this point i turned the car off and removed the hose, i...

Pretty sure that wasn't real since it was for old spice.

Dream Theater FTW!

My 89 turbo takes at least 10 minutes to warm up. even after i installed a new toyota thermostat. the only mods to the cooling system are a koyo rad and throttle body and idle speed valve coolant bypass. have a brand new water pump and fan clutch also. even at op temp it shows slightly below...

Hi i have the same problem with my driver side switches. i pulled it out but i dont know how to take it apart without breaking it, and exactly where to clean. could you help me out IwantMKIII?

theyre not narrower, theyre 225's. I got em from a buddy at sears so i know theyre brand new.

All of them? :sarcasm: hey i didn't say it looked good either

that doesn't look bad... i guess ill post up a pic when they're on too.

alright thanks guys im going to try them on next week