Recent content by Needboost

does anyone have any pics of a freshly painted with a 3H1 paint code?

what fender mods did you have to do to fit these do your fronts rub and did you get to keep ur fender lining?. im gonna hav to roll my rears but i think all ill have to do to the front is bend the tabs a little.

im about to get my car aligned i have xxr521 front 18x8.5 +25mm rear 18x10+25mm putting 245/40/18 front an 265/35/18 rear and im lowered on h&r springs. what are the alignment specs most of yall run so that i can let the guy kno at the shop what specs that he should be close to.

with that being said if im running h&r springs and shocks will i habe problems with a 10 inch wheel in the rear with 265s?

are you lowered also im on h&r springs and thats pretty low. im just asking cause ive already had to send my front wheels back and get a different offset just dont want to get to big of a tire or to small of a tire and have alot of sidewall stretch. with 235/245-40-18 front or a 255/265-35-18...

Hvyman. Thats what lug nuts I have. Could you read my other post to see if you can help me out with my rubbing issue?

an the guys running 521 are yall running hub centric rings if so what size would i need

ok guys i may just be over thinking this. but i recieved my xxr 521s tonight and went to test fit them without tires mounted yet. the car is up on jack stands so i mounted the left side fronts are 18x8.5 35mm offset and 18x10 25mm offset in the rear. on the front when i turn full lock to the...

hvyman what do you think would be best 235-245/35/18 for the front on 18x8.5 35mm offset .. and 265/35/18 on 18x10 24mm offset for the rear xxr 521s? im also lowered on h&r springs

ive seen a few with 18x10 all around and i like the look. but i just kno ill be pushing it throught the turns and dont want to rub with every bump. that why i was thinking about 8.5 in the front.

borhor what do you think would be a good set up for me? wheel and tire? 245/40/18 for front and 265 or 275/35/18?

ive been looking at the xxr 521 trying to determine what size tire and the correct offset i should go with for front and rear and im lowered with h&r springs. front would be 18x8.5 with 25mm or 35mm offset rear wold be 18x10 with 12mm or 25mm offset what would be the best offset and what...

I have install a new wheel bearing and bought new axels. so I put everything together and bearing spends freely but when I have the seals installed and put new axel in and tighten axel nut its like it gets seized up and wont spin. but if I pull the inner seal out and re enter the axel and...

still looks good tho. is that factory paint 3h1?

man that looks great what kind of wheeles are they?