Recent content by Moy

Looking good man! I unfortunately do not have a great condition or new factory shift knob, however... I would be willing to buy that TRD knob off you ;) haha. Or if you don't want to sell it... do you have a part number for it by chance?

Progress is looking awesome! Next time I'm visiting my uncle in Laguna Niguel I'll have to look you up and pop over to MV!

Ronnie, what is the price on a set of rear subframe bushings, and also the rack bushings if you still produce those?

I think there should be a slowest 7m powered mk3 section... haha. First time at the track was a 14.97 @ 95.42 mph... can't find my slip right now though. Blown stock ct26 @ 8psi, 250k mile 4.30 lsd, bald street tires, etc etc

Custom doesn't count as rare. It counts as custom lol. I have a set of RS*R Race springs as well. Getting harder to find since they discontinued production and none are left in stock.

Prof / Sheepdog Sport Exhaust catback. Not sure of how many are in North America haha. http://s118.photobucket.com/user/skaskank99/media/DSC02745.jpg.html?sort=3&o=241 http://s118.photobucket.com/user/skaskank99/media/DSC02744.jpg.html?sort=3&o=240...

a stock head gasket torqued to proper spec should last the life of the vehicle, or until you overheat and blow something...

Check the block and all threads real carefully to make sure none of the threads stripped out. I'd also say check your socket and/or the nut... I've seen sockets break and nuts break from too much torque and they make a loud crack sound

Oh no, that was Xavier's car that was boosted? :/

Call up your local or favorite Toyota dealer and ask for a quote for Part # 53341-14100 You'll also want the clips: 90467-08081 or 90467-11035 They're different types of clips. Taken from the online TSRM/EPC (prices are not accurate, prices have increased probably 20-30% from what I've seen...

Most decent alignment machines will have information set in their programming that has a read out for factory alignment specifications. Some/most of these will also have a place for you to adjust the parameters that determine what specification should be (the machines we had at the college I...

Out of curiosity, did you change your fuel filter when you installed all of your other fuel system upgrades? If not, a partially restricted filter could cause lean conditions at idle due to low flow, but at higher pressures the flow might improve. Also, how did you install the Walbro? Did you...

Run a line from the plenum to the BVSV. In said line, run a one-way PCV valve so that under vacuum fuel vapors are pulled into the intake, but under boost the valve shuts so that you don't over-pressurize the canister and tank. The tank will naturally have a very low pressure, which helps to...

Awesome car and build! I noticed your build sheet said Carrillo rods? Are they custom, or does Carrillo make off-the-shelf rods for the 7m?

Got my shit running for the first time in 6 months hahaha