Recent content by mk3sons

  1. M

    Any 2 Wheel Lovers on the forums

    Just picked up a pretty clean 96' GSXR 750 a few weeks ago. A little cold but i'm loving it :)
  2. M

    Ac delete and no fan shroud..

    Also being from NH i would keep it.. it can get pretty damn hot.. And there is supposed to be a tensioner bolted to the right side of lower timing cover kinda on the same level as the water pump.. there should be two holes for it there.
  3. M

    Holset HX35 leaking oil from turbine?

    Could go ether way. just add a restrictor it needs to be done anyway..
  4. M

    ABS delete question on brake lines

    Pretty sure its well known you can stop faster by locking up the tires in snow, right? Obviously without as much control...
  5. M

    fml. i hate this car

    I had the same problem.. went to town on that shit with an impact gun.. it tightened it butt.. I wouldn't recommend that though because, uhh its probably dumb and incorrect and you will break it
  6. M

    Stock internals? How much power have you gotten out of them?

    I can show you a bent one.. if it counts after vacating the side of the block
  7. M

    fml. i hate this car

    why cant you tighten it?
  8. M

    2jzge-t egr

    the thing off of the top of it? yea
  9. M

    2jzge-t egr

    No it doesn't. That just says how to remove it. i want to keep mine. How did you run your vacuum lines and egr vsv and what not to make yours functional?
  10. M

    2jzge-t egr

    So did any one keep their EGR during this swap? I want to keep mine but i am unsure of how to hook it because there are so many more vacuum lines for the 2jz EGR system than there are for the 7m. Any input would be appreciated.
  11. M

    no acceleration and low idle code 41 and 51

    http://www.cygnusx1.net/Supra/Library/TSRM/MK3/manual.aspx?S=FI&P=101 Read that a couple times
  12. M

    Charge pipe hitting hot side of turbo (na-t 2jz)

    Sorry, i cant weld aluminium and after looking at some more build threads there is a bunch of guys running the stock cross over manifolds.. Why are my hot sides so big :(
  13. M

    Charge pipe hitting hot side of turbo (na-t 2jz)

    Id love to try something like that. i wish i knew how to weld..
  14. M

    Charge pipe hitting hot side of turbo (na-t 2jz)

    Do you guys think if i heat up all 6 runners of the exhaust manifold up i could bend it down a little for a little more clearance? i have sold motor mount so it wont be moving around.. I think that would give me enough clearance to weld on a pipe..
  15. M

    Charge pipe hitting hot side of turbo (na-t 2jz)

    If i welded it would it make my intake temps be too hot? touching the hot side of my turbo and all.. or would the coating help that much.. there literally isn't even room for wrap on there I wish i could afford a ffim :/ edit: a pic for you 525gte
See more
Top Bottom