Recent content by bikerdude198

Tccs..... I mean the tems.

Hello, i have just finished a jdm engine change into my 1990 supra turbo, it has abs and cruise but no tccs. Before engine swap everything worked fine... now heater, signal lights and dash lights are not working. i used the ecu and harness from original "north american" engine. there is a white...

http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&_trksid=p4712.m2000054&item=220593792760&viewitem=

a trick i use with snowmobiles to find intake leaks, carefully spray a little ether ( usually known as quick start or liquid fire, available at most auto parts stores ) around and listen, the idle speed will change when you find the leak. Might want to put on safety gogles when working with...

a 4x4 r154 if that counts, used r151f main shaft with input shaft from r154, gears from r154, bellhousing from r154 and front case from r154, rear case, rear shafts and gears from r151f, then the stock "re bearinged" chain driven transfer case. Its for my 1990 7mgte powered toyota pickup.

The instructions with my walbro say if flows 255 lph at 100 psi? So id say 100 psi is in the neibourhood of safe, but there would be no need to ever run that high,

ok thanks, ill give that a try

Hello im new here, also new to supra's but am a long time die hard toyota fan. What im doing is swaping a 7m into a 1990 4x4 toyota pickup, ive gathered up a jdm engine and all the parts needed, its installed and ready to start... but i dont have a fuel injection resistor pack. I tried through...

Hello im new here, also new to supra's but am a long time die hard toyota fan. What im doing is swaping a 7m into a 1990 4x4 toyota pickup, ive gathered up a jdm engine and all the parts needed, its installed and ready to start... but i dont have a fuel injection resistor pack. I tried...