Recent content by 87Tmk3

Did the YouTube link not work? I can try and reupload it

https://youtu.be/_biYTffXugE pulled the motor awhile ago to reseal a couple things and try to clean the bay up, After getting the motor to start there is a noticeable ticking. The noise does go up with the revs. Motor did not make any noticeable noise before the pull List of things i did...

So you can see what it takes to put the front calipers from the Evo on the supra now lol. I like the feel of my Evo brakes just never have time to see what it would take to make them fit on the supra

http://store.driftmotion.com/static/i-new7mickit.php think it comes stock that way

http://www.cobaltss.net/forums/how-guide-43/how-add-aux-input-pre-07-cobalts-184854/index10.html the idea is about half way down the page, it was done on a cobalt but think if you could tap into a power wire and ground wire might work but im not to sure just thought i would throw this idea out...

Well if you guys say they won't work will just stick with stock ones. Just thought it would look better then the ugly ones you can buy to replace the flip up ones. Thanks for the help!

i want my headlights to look like this guys in the race but having trouble figuring out how to do it was hoping some one could point me in the right direction. you see the car at 1:50 http://www.youtube.com/watch?v=LAGnlrvxfow thanks for the help!

If people say the pumps are the same is it possible to just swap the pulley? Be a lot easier if I could

Thanks for the help!! The pump is newish got it off eBay but its a n/a pump. Only reason I ask though is cause the power steering really whines didn't know if it cause of the pulley being from a n/a or just need to bleed the system Thanks again for the help

Have a 87T with the original motor but have a quick question about the difference between a n/a and turbo power steering pump and pulley. Are they the same size or big difference?

Have a 87T with the r154, just got done with a bhg, go to put the car in reverse and its grinding also little hard to put into gear. when we put the tranny in we heard two different things that you didn't need a clutch alignment tool and then we heard you did well we went with the don't need...

The car ran before the rebuild, but the person we bought it from spun a rod bearing. But yes when pushed on the peddle felt normal. When we do start it it'll run for like 2 seconds then it just dies out like no more gas and since we can't give it any gas just craps out and dies.

Have a 87 with the stock 7mgte just had the motor rebuilt and when fired up and try to give it some gas nothing happens. Everything should be hooked, little puzzled please help