Recent content by 1987supraomega

  1. 1

    Broken Thrustwasher

    Yea its popping out of first. Bob I would appreciate it if you could hook me up with his e-mail if he does want to sell some.
  2. 1

    Broken Thrustwasher

    Hey guys, finally gonna start digging back into my supra haven't driven or even touched the poor thing in a few years. I am pretty sure that the thrust washer is broken in the tranny. Has anyone come up with a definite fix for the weak stocker. I have a 6 puck unsprung act clutch in it and I am...
  3. 1

    R-154 problem

    Yea i had a bad feeling that it may be the synchros thanks for the help i'll try the redline fluid first before i totally give up on it
  4. 1

    R-154 problem

    OK so I called the local toyota dealership today and they recommended 75-90 full synthetic. So does anyone have any ideas what may be causing my problem.
  5. 1

    R-154 problem

    Well tonight i had this happen for the first time but when i go to put the car into first going from reverse or when i'm downshifitng like at a stop light i usually only downshift to 2nd then put the car into first when completely stopped, when i go to take off the car will pop out of first...
  6. 1

    Running lean?

    hey i've got the same problem so if you find out what the cause is let me know
  7. 1

    Lean condition

    Would that also cause my car to have a rough cold startup, b/c in the morning when I go out to start it it lopes like a cammed big v8 for 10 to 15 seconds at about 600 rpm then it will pick up to normal idle speed and run fine at 1000rpm from there on out. I know these cars are cold blooded but...
  8. 1

    Lean condition

    Alright what is a fpr? sorry i'm still learning and don't quite have all the acronyms down yet.
  9. 1

    Lean condition

    Alright I got a new symptom when punching it the car will hesitate and basically drop of the A/F gauge then a few seconds after full boost it's like something switches over and it'll jump to ideal and take off, it seems as if a sensor is malfunctioning any ideas which one?
  10. 1

    Lean condition

    Got the new O2 sensor today, and retightened the IC pipes still no good, anyother suggestions. This only seems to happen in 4th and 5th gear when punching it.
  11. 1

    Lean condition

    Got the new O2 sensor today, and retightened the IC pipes still no good, anyother suggestions
  12. 1

    Lean condition

    k thanks Dr. J, They have nothing to do with my problem, I think I'm just gonna go order a new o2 sensor and see where it goes from there.
  13. 1

    Lean condition

    Yea i understand that but it seems as if it something electrical b/c sometimes like i said it will be just fine and go like hell. I did check the error codes and I think I'm getting a 12, and 22. Anybody know what these are I don't have the owners manual. I did check most of my pipe clamps and...
  14. 1

    Lean condition

    Wouldn't loose IC pipes cause rough idle and so on? Bcause it idles and seems to run fine other than under wot