I just got my
2 Fusion Encounter 12's
-Power Handling – 400 Watts
-Voice Coil – 2” Kapton SVC
-Impedance – 4 Ohms
-Free Space Resonance (Fs) – 27Hz
-Efficiency (1w/1M) – 91dB
-Frequency Response – 23Hz * 3kHz
With
1 Sony XM-d400p5
-Channel Configuration 1 mono
-Low Pass Filter (variable) 50-300 Hz
-MOSFET Power supply
-Max. Ouput Power : 1 x 800W at 2 ohm
-Rated Ouput Power : 1 x 400W at 2 ohm
My problem is that i can keep them playing only at low levels of the cd player, and when i start turning the volume up the subwoofers go out and the amp goes into protection mode. The cd player keeps playing and doesnt skip a beat although without the subwoofers going. If I turn off the unit and turn it back on the subwoofers will begin playing again once I turn my volume to that level off where they stop playing before.
I've checked my ground and checked it again and it is fine.
2 Fusion Encounter 12's
-Power Handling – 400 Watts
-Voice Coil – 2” Kapton SVC
-Impedance – 4 Ohms
-Free Space Resonance (Fs) – 27Hz
-Efficiency (1w/1M) – 91dB
-Frequency Response – 23Hz * 3kHz
With
1 Sony XM-d400p5
-Channel Configuration 1 mono
-Low Pass Filter (variable) 50-300 Hz
-MOSFET Power supply
-Max. Ouput Power : 1 x 800W at 2 ohm
-Rated Ouput Power : 1 x 400W at 2 ohm
My problem is that i can keep them playing only at low levels of the cd player, and when i start turning the volume up the subwoofers go out and the amp goes into protection mode. The cd player keeps playing and doesnt skip a beat although without the subwoofers going. If I turn off the unit and turn it back on the subwoofers will begin playing again once I turn my volume to that level off where they stop playing before.
I've checked my ground and checked it again and it is fine.