all i want to know is if it will work. i know it will bolt on, but i want to know what compression im looking at, and if it will even rotate without smashing stuff? i know i can just run a super thick 2 or 3mm head gasket to make up a tiny bit of the room. but any sound factual knowledge would be appreciated:icon_bigg.. all i have found is guys doing 5m heads on 7m bottom ends but not the transverse..
7mge head on 5mge bottom end
- Thread starter pimpinx7
- Start date
ok, i found a threa on her finally of a guy who did it. but he modded his 5m pistons to bump compression. would the valve relief's in the 5m pistons be a problem?
I believe Aaron Garney did this quite some time ago- or at least was looking to do it. He is normally active at celicasupra when he's posting.
Sent from my X10i using Tapatalk
Sent from my X10i using Tapatalk