where is the best place to get a cps because i think mine may have weak pick ups. last time I was at the dyno my car was missing and sputtering by it was very inconsistent when it happened. I bought a new wiring harness but the tuner said it seem like it had weak mags.
Has anyone considered replacing the CPS with an AEM Engine Position Module link below.
http://www.aemelectronics.com/engine-position-module-puck-universal-1283
I would think you could just remove all the sensors out of the cps and make a mounting bracket and coupling to connect the shaft...
I would say get the seat reupholster first them match that color that way everything matches nice. if you do dye the interior I would use the adhesion promoter so it sticks well and make sure you buy the right dye for the material you are dyeing i.e. carpet vs vinyl ect.
The more i looked over my harness i found some wires that are cracked and have copper exposed. So i just bought a harness form someone one the boards that bought it new from the dealer and only used it for 3 years.
OK thanks for the help. I plan on grounding everything when I swap the motor into my new shell so I am hoping that clear up a lot of issues. If it is the cps or knock sensor do you think replace the wires including the pins in the clips would solve the problem?
When the car was tuned it had the stock ignitor but last summer i switched over to the DH61 and followed your write up. I am sure that I wired it correctly I triple checked it and made sure I didn't mix up the C2 and C3 wires. The car revs fine when its in neutral under no load but when their is...
I have some log files from from my car would anyone be able to tell if their was an issue with the harness? I got my car tuned a few years back and it made 430 wheel but it never seem to run perfect all the time. some time it would run great but other its seemed like it was dropping a cylinder...
I will have to check it carefully but I know it was getting pretty hot under my hood that some of the wire loom melted. Also some of the wires but not all seemed kinda brittle.
I have heard lot of people recommend getting a new engine harness when using A AEM EMS, They say i got rid of a lot of issues with tuning. Has anyone had success with their old stock harness or should i just bit the bullet and buy a new one from tweek'd performance?
I am thinking of using the AEM pencil coil and doing a way with the dh61 ignitor and 7m coils. I emailed AEM and they said you can wire them straight into your ems. has anyone used these before? I have heard that even with the dh61 ignitor people still have problems with noise messing with their...
thanks for the help I will double check the wiring, I just plugged the ecu in so i will have to go back and ground the case. as for the plug gap I have them set at 25 because the guy tuning it said that it could break up in the high end when the methanol is sprayed. I am going to set them back...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.