Search results

And Pink to top it off.

I have an 86.5 n/a brown, with tan interior. Looking for a driver's inside door panel for it though. Don't see too many tan fabric interiors anymore.

I would look at the Neutral Start Switch ( if it's an auto), and run the shifter through a couple times and try again. That's how I found my bad NSS.

I have the reverse problem. I get warm air as soon as I set temp to 66 degrees. I have to set to 65 to get completely cold air.

I had the same problem with my 86.5 auto tranny( no reverse lights). It also wouldnt start occasionally until I ran the shifter thru a couple times. Turned out to be the Neutral Start switch, for both problems. New one fixed the problems. couldn't do it myself, too tight under there by the...

Make sure that your sawblades are put back on in the proper direction after any tire removal.

Yes, there is a spacer that goes under the nut. Same thing happened to me, couldn't get the nut off. Had to find a way to hold the chrome shaft thru the spring and high up enough so that spot wouldn't enter the shock when fully compressed and slowly remove the nut. Must be the correct spacer...

It might be a bad brake light switch... mine stayed on, even with car switched off. Had to re-adjust it all the way to pedal, can't see how it was out of adj, as it was still very tight. I think a new one is in the works for me.

I had a rattle in my 86.5 front end for years. Had the dealer check it, replace shocks and everything else. After years of frustration, I noticed that the hood was not tight when latched down, still had some play, which caused the noise when going over bumps. Tightened the hood latch and problem...