I figured out the problem. I tested power at the iacv and found it was on switched ignition power, not main relay power like it should be. I still don't know where I went wrong with the wiring, so I ran new wires to main relay power from the fusebox. So nice to have idle control!
My 1JZ IACV will not open before a cold start. I've tried two IACV's with the same result. I can open the IACV on the bench by jumping the pins. When I put it back in the car, the ECU lets it idle down as it should while it warms up. Until the next cold start when the valve is still closed. The...
Suddenly my 1JZ cuts fuel when given over half throttle. Dies and wideband reads full lean. Once it drops under 1700 rpms, it returns to normal. Drives normally as long as you don't give it more than half throttle. My ECU went bad and I had it repaired by Driftmotion. The IACV still doesn't work...
I was driving down the highway and all the sudden ignition got cut for a second. Did it two more times until I got home, died in my driveway and would crank but not start. Fuel pump running, power to coils, injectors, and cps tested good. Was pulling my hair out triple checking all my wiring...
Few updates to the build. I was having cooling issues with twin 12" efans. First, I tried Driftmotion's modified LS400 clutch with a 7mgte blade. This happened on the first drive:
Fan clutch was locked way too tightly, I would strongly advise against using this combo. Switched to a 2JZGE...
It was fine on disassembly of the broken one, I ended up breaking the 1-2 shift fork. I was merciless on the old r154, going to go easier on this one for sure.
Hoping I can get some help with this. I bought a brand new R154 from a friend that had been sitting for 4-5 years. Ordered new from Toyota. I swapped it in my car that had a broken R154. I drove it for a few hundred miles taking it easy. Used Redline MT90 in it. Shifted great. I decided to go...
A miracle happened and I scored a brand new R154. Changed clutch while it was out, disc was burned after loading the car on the trailer in 3rd gear (only gear that worked). I sledge hammered the trans tunnel some more, it finally fits without hitting anything. Getting pretty familiar with engine...
I was at a drift event and shifted from 1-2 on the rev limiter without letting off the gas and heard tremendous pops and grinds. At first it stayed in 1st when trying to shift from 1-2, but after I tried to use the other gears it engaged 3rd and now only 3rd works. 1st and 2nd act like neutral...
I could never find any info on my jzx90 harness either. What I can tell you, I'm pretty sure it's the plug in your hand, 4 wires are water temp, oil pressure switch, tach, and ground. Use a multi meter to find the correct wire. Tach is solid black wire. The plug underneath, there are two large...
You want to take a real close look at the engine you're buying. If you look at the pics of the one you posted it doesn't look like it comes with an ecu, map sensor, ignitor, or starter. The extra little things can be hard to find and add up. I ordered one from JDMracingmotors and it came...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.