Search results

I have a broken window, the one behind the driver's door. Is there anything special about replacing this, i.e. special tools or adhesives? I have the glass already but I want to be prepared before I tackle it this weekend. Thanks

Under light - moderate load (200-300 mm/Hg) and roughly between 3500-4000 RPM my 1JZ goes very lean. On my WB display it goes from 14.x - 16.x during this spot. I run 440 injectors, BC cams, an AEM FPR and a S-AFC to trim the fuel. It was doing this prior to all of these mods, so I don't...

The heater control for my 88T is not operating properly this morning. Symptoms: - Fan works when you manually push the buttons manully. - Auto mode will not work to heat (set to max - 32C), but works perfectly fine with you you set it to 18C to cool the car. - When you manually run the...

I completed my 1JZ swap last year with the A/C. I vac'ed the system and charged properly (I thought) The A/C blew cold air and the compressor cycled on and off as expected. This year when I went to try it out, the compressor wouldn't engage. I checked the pressure on the low side and it...

I have a noise coming form the P/S pump that sounds like squeak. Not a whine. If I rev the motor to about 1500 RPM it goes away. Also, I tried shooting a bit of WD-40 in the area between the pump and pulley and the noise temporarily went away as well for about 15-20 minutes. Is there a...

I'm trying to get my A/C set up after my 1JZ swap and everything seems to be fine except for the compressor magnetic clutch. I connected everything up as in this guide: http://supraforums.com/forum/showthread.php?t=219596&page=1. The A/C relay line does switch to 12v as its supposed to. I...

I just got my 1JZ swap done and I'm running a t61 single and an external 46mm wastegate. With my boost controller (Greddy Type S) off, I peak at a consistent 10 psi. With it on, the lowest it will go is 15 psi (all knobs set to min). I have the solenoid set up as per the instructions (COM...

I have an 88T that looks like it has 87T wiring (yellow plugs). I've followed the instructions on the following sites: http://web.archive.org/web/20060323191804/www.1jz-gte.us/92Supra6.html http://www.supras.nl/index.php?option=com_content&task=view&id=34 After all of this is done, I have...

I'm going to setup the A/C in my 1JZ swap using the 7M lines / 1JZ compressor technique. One thing I could not find when looking this up was if I will have to recover the R-12 in the system prior to doing the swap or will it leak out when I swap pumps. Thanks

It looks like the previous owner of the 1990 JZA70 I bought (for my 1JZ swap) replaced the radiator with a non-stock one. I can't find a temp sensor in it anywhere. What does this look like in the radiator and / or what does the plug look like? I have no idea how long this was run this way...