I have a Koni Electric Supension(tems)+koni controler
I have a koni supension controller that i can set in 4 steps to different levels off hardness.
I can control the front and and back schokabsorbers butt i have only the back schokabsorbers.
Does anyone now where i can find more info...
WILL THE STOCK FEULPUMP FROM A 7MGTE ON A 1JZ BE ENOUGH?? PROBLEM???
I have a problem.
I have build a 1jz in a supra mkiii whith a auto tranny.
I am using a suprastick manual on the steeringwheel so i can shift when i want.
Butt it will not run further then 4000RPM.enigne stumbels around...
update info
i now what the problem is now.
i need advise about how to solve it.
the problem:
i used the old autotrans ECT ecu i did not wire the L1 L2 and L3 wire's.
normally they go to the ecu.butt the soarer ecu has a different signal.
how can i solve this problem???
check this...
build 1jz+autotrans in a mk3 problem goes no higher then 3000rpm??
i have build a 1jzgte whith auto trans in my mk3 supra butt the trans shifts up by about 2500/3000rpm.
what can be the problem???
throttle valve?
i installed the autotrans cable to Toyota specs.
need some help please.:1zhelp:
thanx for the info.
1j bell house will directly fit.great!
butt i also heard that a 3j bell house will work whith some modification.
butt i will use the one from the soarer then.
auto tranny from a supra/soarer on a 1jz what parts do i need for it???info...:1zhelp:
I want to use a auto tranny on a 1jz.
I have one auto tranny from a 7MGTE and also i have the one from the soarer 1jzgte.
Wich one is the best option to use?
I geuss the one from the 7MGTE type 30-40LE...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.