Recent content by simon

Got some places to check out? River side bar/restaurant, or nice camping site? I see this place from the water side all the time. Would be nice to tour around by land. Some gorgeous properties around there.

Just bought a caliper set and realised after the fact, they were for 03 and up. Crap, lighter /smaller Nissan rotor I guess?

God, just read trough the hole thread. Had to see what was the outcome. Keep your spirit up, driving will be rewarding. What the hell? 5 am! This is going to be a long day.

Since unigrade oil came out, multi-grade oil stop lubing?

And... They can be found in winter time by the side of the trail. Could have grabbed 2 sets last winter, damn..

This: Also, you said it was 6 bolts mains? Some trough the side? UZ guy tought they were cool... Back to the drawing board !

http://www.pirate4x4.com/forum/showthread.php?t=763645

Indeed

Looks cosy like a Caddy. Nice interior to spend time in.

st'ill buisness? If you hesitate about spending the hard earn money for that small of a difference, know fiberglass? you already have a mold. 600$ I would use elsewhere. Sanding sucks though, must take a while.

Yup, made my own set-up, thanks for the link. Add up to a bit more for all 1/2" parts.

http://www.ebay.com/itm/12-ROW-10-AN-BLUE-ALUMINUM-ENGINE-OIL-COOLER-FILTER-RELOCATION-LINE-FITTING-KIT-/110791973382?pt=Motors_Car_Truck_Parts_Accessories&fits=Model%3ASupra%7CYear%3A1992&vxp=mtr&hash=item19cbb75a06 No thermostat or angle fitting but a good start, i guess.

That oil could had more detergent and dispersent additives than your previous brand.

I use a multibit screwdriver like a pickquick instead of T handle. Was in the range kit when I shot it first, and found out how tight the bullet was. All you need is to go trough the first 2 inches.

Hand tight, then a quarter of a turn. So they say. Same thing goes for new compression fittings. http://www.vansaircraft.com/pdf/Torque_Spec_Aluminum_Fittings.pdf