Recent content by pocketrocket07

Im in class right now also, so I cant call you.

Yeah, im here. Whats up?

Yeah looking for the 6 port flange to connect to the exhaust side of the head. Or, do they use 2 3 port flanges?

....

Looking at making my own turbo mani and Im wondering where I could find an exhaust flange. Any site or somewhere I could find one is appreciated.

So a little background...finished my 1J swap drove it hard and either melted a piston or rings in cylinder 6. Pulled the engine out, but havent taken the head off yet to see the damage. A local guy put a 2JZ-GE long block up for a slamming deal and I am thinking about picking it up. I do have a...

Im looking at a set of wheels, but I have a question as far as fitment goes. They are 18x7.5 with a 45 offset. Will these fit without complications? Would I need any spacers or such? Any help is appreciated. Thanks.

Thank you for the reply, thats all I needed.

Anyone?

Ive searched and Ive read around but I just want my notion to be confirmed, the Greddy BCC intended for the SW20 Mr2 is compatible with the Supra. Im 1J swapped with BPU. Im not asking any other options or opinions just whether it will work and if so are there any changes that need to be made...

OK so after my 1J swap, my lighs worked fine in the dash, including the HVAC lighting. So I have a buddy install a JVC dek for me and after the install, I lost my lights when I flick the switch. I checked any fuses I though relevant under the dash, but none seemed to be blown. Do any of you...

Can I test my knock sensor some way with a multimeter? I have it narrowed down to the knock sensor but I want to test them. What should I be looking for I I can test them too? Thanks

Probably because it's 29 degrees and snowing here...

The lines are stuck under the car and if i wanted to replace the drop in assbly i would have to order it from toyota. only problem is that toyota shows no record of any assbly in the nation and estimate nearly 2 months for one to come in. Thanks dugums i really appreciate it. happy turkey...

I have a good idea of where the fuel pump is and the fact that I need to drop the tank. What my question is that where in relation to the sending unit panel is the pump drop in arm. I would like to just cut and seal the metal in the hatch so I dont have to drop it out. If anyone could give me...