Ok this is what I came back with
m-rel is 9.5 instead of 10-14
Idl no voltage- change ecu
Vc no voltage- change ecu
Igt no voltage (I cant start it to test)
Vs no voltage (I cant start it to test)
It wasn't on there but I tested the ecu ground (e1) to the body and got 0.01 volts...
Ok I am getting 12 volts on those wires at the ecu connectors. The intake manifold grounds are tight. B + at the diag port is getting 12 volts. And I cant find one up there that is m.
I really do appreciate the help hvyman.
The cattle gaurd is just to keep cows from walking down the road but allow cars to drive over without a gate. Its bumpy going over them but doesn't really do anything... until now. I checked the efi relay and all the fuses. Even un related ones. On wiring harness at ecu I get a reading of power...
I have a 89 n/a and I went over a cattle gaurd and my car stalled. I tried starting it with no luck and had to get towed home. When I got home I discovered that I was getting no spark and no injector pulse. I tried to read the codes and no check engine light at all when in the start position (or...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.