If i just hone the cylinders and do everything else besides boring, like polish the crank new bearings machine the deck, ect, and the pistons are fine will it still be a risk of it burning oil through the pistons with new rings if i dont bore it out?
Thats what im worried about, the surface of...
Yes barely though. Ok so if i do hone/bore my block will i need new pistons and pistons rings? What about the rods? Because if i take it to the shop for a bore or hone i have to remove the pistons either way. So again, will i need to get new pistons if i bore the walls? What about if i just hone...
I did remove almost all the crap off the valves. I didnt do a compression test but the car ran fine and the idle was fine when i took it down the car transport and into my garage.
After inspecting my cylinder walls a little more i seen some scuffing on them. The factory crosshatch looks fine just the scuffing. Should i be worried about this?
I have a question about my exhaust valves. They have some sort of hard deposit hard to remove with a toothbrush on maybe less than half of them. The intake valves dont have any buildup just the exhaust.I let them soak overnight in seafoam, but they are still rocky like. Is this normal on the...
My block is only .0002 or .0003 of an inch out of spec, says the manual. My .002 gauge barely slides in but my .0025 wont. I still need to give a nice finishing touch with a scotch brite to fully get a true reading.
Thanks bud. I only had the #6 cylinder that was shiny and with somewhat with water moister , no water inside just water moister, the rest of the pistons were normal carboned up and stuff. Im for sure getting the ARP studs and a toyota gasket. Yea i just want this engine to last me until im...
I took off the head and i cant see were it blew the gasket from. Im not planning on removing the block. I used a straight edge and a 0.0015 gauge and there was like 4 spots it went through but i still need to remove completely the gasket residue of the block. It had already blew 3 hg with this...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.