from what ive seen. never a prelude body going that fast without boost or bottle. the fastest ive seen is only 1 that i know of. which is fully built(not supporting mods).
built, ported head, big cams, built bottem end. side exit header on full slicks. it ran the best of 12.9
im not saying that...
hvyman
my old civic look way cleaner and will get way more people's attention just cause its an
SI.
its not ugly people just have their own likes and dislikes. hell you might even think a hot girls look ugly and a fat girl looks better.
not really cause they cant get traction. its cause they dont use a large 26 slicks. they usually run 24.5 slicks to not break trannys.
ive seen alot of honda going over 800whp and 500tq with a 72mm turbo with stock trannys that tuns 10s. t4 class. hotrods and 9sec cars which runs straight cut...
Boosted516
if i fixed all the problems it had it would be into 12's or even with better tires
honda trannies do hold over 500tq. even though they dont put out as much TQ cause their FWD they still get over 7-800whp on it stock.
for a na trans it is good enough compare it to like the w58 which...
do you think this is a good buy.
rear sumped. fan clutch
automatic/ so it hasnt been smashed on as bad as 5sp
i plan on buying this if its good. not much to convert.
any opinions...
AND no honda trannys can hold more boost than a w58, r154
i bet the fastest 7m wont even beat a d17 single cam turbo.
a record of 1/4=8.9 at xxx mph......power to weight ratio.
WhtMa71. has a civic. LOL
and i still get 32mpg on my boosted civic
dont hate on hondas. i bet most of you have one for a DD. i used to own one and was proud of it.
enjoy some pics...
built B18c1 (sleeved, mahle forged pistons,eagle rods, etc)
t3/t67 garrett turbo. topmount manifold. tial 44mm WG. HKS bov, greddy FMIC
1/4=13.1 at 114mph on a 104 degree hot...
black89t
im not sure if it was rebuilt before, but i know its a replacement motor though. a shop did all the work for the previous owner. cost total of $2200.
jdub
ill just go with the oem HG route as i dont want to waste any money or time.
ill do the flush and use coolant flush also to get...
Zumtizzle
thats what i was thinking. that it looked pretty clean compared to other BHG on here.
ill check for the knock later on when i have time
i just want to drive it to work daily until i save for a 1jz single.
so basically ill just need to machine the head and put OEM HG and stock studs and...
is the block bad or is it just on the safer side to do a rebuild
should i just go 1jz instead?
Because if i did choose to rebuild it I would go forged piston/rods and it would cost almost the same amount.
im in the process of doing a BHG.
Is the BHG bad enough to mess up the bearings. The previous owner noticed temp going up and stop the car.refilled water and drove about 5-10 mins slowly back to work. After he noticed it was a BHG he towed it home. Oil is milky but the BHG isnt that bad. Should...
im kind of new here. im rebuilding my supra and was collecting aftermarket parts for it.
what launch control is used with our cars.
i already have a safc. a AVCR
i wanted to know where and what brand launch control to buy.
i know MSD has it but dont know if it will work on our cars. info...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.