Recent content by 1jzMoe

I wouldn't recommend you get stuff from eBay, you dont know exactly what you are getting . Just check out the authorized vendors part of the forums, they are there for a reason and they have the parts you will need and more.

Don't quote me on this, but i am pretty sure the one for the 2jz-gte should work.

well i just got a hose and connected those two together, i havent had a problem.

You can use the 2jz Map Sensor, it will plug right in. If you do go with the 2jz map sensor you wont have to retune your car, my 1jz had the same air-fuel ratios with the 1jz and the 2jz map sensor and nothing had to be changed

For the wiring just read the stickies in the top of the other engine tech section. the Map sensor is not located on the motor, it is located on the firewall by the brake booster.

Call up Driftmotion, i know that they have piece to block off the extra oil drain line. As far as the coolant lines, unless your turbo has water cooling, block off all the old coolant lines that used to go to the twins. and block off whatever vacuum lines you are not using

Thats why you should be buying from and supporting the community vendors. They generally know what they are doing, and and have tested and checked their products to make sure it works.

I am running electric fans on my 2jz car with no problems even with a bigger turbo. I also ran electric fans on my 1jz car also with no problems which also drove around florida for a whole year with electric fans on the highway and city and temps stayed stable. Make sure the area between your...

Check out the page below and make your decision, i stand by what i said. I am using the BIC mounts and they work perfectly. http://bicperformance.com/products.htm Scroll down

it is possible and a pain in the rear end and will take you all day to do. i recommend you just pulling the motor, alot easier.

You will need both the front and back of the pump You shouldn't need to replace the tensioner unless the pulley is making noise.

yup, thats why i dont buy off of ebay, and buy off the forum vendors

I would say you are correct, those do look like pre 89 motor mount brackets. If you go to the bic website you will see a comparison between the two. To swap a jz motor into a mk3 you will need those brackets (unless it came from a JZA70 supra) because you cant use the ones that were on your 7m...

Does anyone in the Tacoma/Spanaway area have an Impact gun that i can use? i just need to borrow it for 5 min to pull a crank bolt off of an engine outside the car.

i say dm67,and you will also be supporting the authorized vendors, and if you get the mp70 it will break after a little while