Car harsh on acceleration or deceleration? Most people point to the Centre Bearing as the culprit but even a badly worn/floppy one is seldom the cause. Check that the Rear Bonded tube in a tube hasn't slipped out of phase, just sight along the Uni joints they should all be perfectly in line....

This seems to be coming up a lot so here's a bit of information for you :- Dump valves - The purpose of a dump valve (also called a blow off valve or BOV) is to try and reduce 'compressor surge'. When you are boosting in a turbo charged application and come off the throttle suddenly (e.g. when...

- Comments

- Comments

- Comments

This thread is intended to provide accurate factual information about 1 piece driveshafts regarding critical speed. All subjectivity and opinions are not intended to be expressed here. After reading all the discussion about critical speed and 1 piece drive shafts I have decided to research this...
15 Comments

It's the rivets. First; this assumes you have checked the basics like fuses, bulb, and switch in ‘Door’ position. Does the vanity mirror light work? passenger visor mirror light Does your dome light work when using the individual buttons on the dome light? (when fully installed) If so you...

Because this comes up every now and then, I thought I'd throw this up, in case anyone is interested. It pertains almost exclusively to the North American MA70. MA70 = Chassis Code with 7M bottom end North American VIN codes: JT2MA70 = MA70 Non-Turbo Trim Level (7M-GE Engine) JT2MA71 = MA70...
2 Comments