Well replacing the oil pump shaft bearings was the last step in my rebuild before assembly, and I was kind of at a loss with how to easily change them and make sure they went in perfectly strait as well as make sure the oil hole is lined up. If you don't do either of these two things you will have...
With the recent surface of some topics regarding E-fans, and the Tari (Thats plural Tarus) Fan, I had been asked to do a write up from a couple members on my install. So here we Go:
BASIC INFORMATION REGARDING THE E-FANS:
Flow Ratings:
~2800 CFM Low
~3800-4200 CFM High
AMP Draw:
130... 18 Comments
This will allow you re-wire your 1987 MKIII Supra so that you can throw away your lamp failure box which causes your brake lights to not work if it goes bad.
If the light on your dash that looks like your car is farting comes on, it means there is a problem with one or more of your lights in the...
Car harsh on acceleration or deceleration?
Most people point to the Centre Bearing as the culprit but even a badly worn/floppy one is seldom the cause.
Check that the Rear Bonded tube in a tube hasn't slipped out of phase, just sight along the Uni joints they should all be perfectly in line....
If you are replacing your valve seals and drop a valve into the cylinder, this is how you can retrieve it. You can prevent this from happening by bringing the piston in the cylinder you are working on to TDC then feed rope in through the spark plug hole, so the valve will sit on the rope should it...
I have took a lot of time editing my words (still learning english) and studying on how this is done. Before I start I would like to say if you can correct me PLEASE DO! I would like this to be as correct as possible. My goal for this is a simpler step by step walkthru for the 7mge owners.
Save...
