I personally think GTOs are one of the best looking cars on the road. I also think the Supra would benefit from vents to relieve some of the heat build up (especially over the turbo) during a hard run and when the engine is switched off. Two birds with one stone and all that, here's a guide showing...
1 Comments

Step 1 - Locate the diagnostic plug on your car which is in the engine bay Step 2 - Open the plastic lid and you will see a number of connectors and a description of each on in the lid itself Step 3 - Use a piece of wire/paper clip/something metal to short E1 with either TE1 (MS) or T...
1 Comments

After deciding that I didn't want to pay the cost of buying an alternator relocation bracket, this is the solution I came up with. Materials needed: Universal Alternator Bracket for a small block, which looks like this: You can get them at pretty much any parts store (mine came from Advance...
2 Comments

Found this link while I was researching IC endtanks. It's a great read and posts flow results for both cast and custom fabbed endtanks. Also has some great info on angled pipe restrictions. I learned a lot. Enjoy. http://dvdtfab.com/intercoolertestlab.pdf
1 Comments

well today i decided to change my rotors because they were getting on my nerves with the scars and grinding noises, while changing them i thought to my self hey i havent seen a DIY thread yet so i grabed my camera and shot a few pics hopefully this is accurate this is my way of doing it good luck...

i posted a thread earlier about an r154 rebuild because my tranny would make nasty noises. well someone wanted some pics so here are some. its kinda confusing looking but its relativly simple when u see it. here is the center plate with the two shafts in it here is the input shaft and bearing...
8 Comments

This is how i did my conversion to a 89+ gauge face, though this thread may help you if you were to get gauges from ebay or so and need help to get the gauge faces off... First thing, I spotted an 89 at the junkyard and I saw the gauges, I liked them so I tore apart the gauge cluster and got the...
5 Comments

I finally put something together that might assist some of you in dealing with this subject. The attachments reference the word "guide", but it is mostly on how I dealt with the issue. Addendum A - contains the images referenced during the procedure in the main document. Addendum B - contains...