View Full Version : ? about cam position sensor rebuild/reseal

January 19th, 2008, 09:18 PM
Anyone else done this? I have read the write up, but was curious who else had done it, as well as their results.

January 19th, 2008, 11:12 PM
I have. Piece of cake. I reused the gear though because owning a 20 ton press has it merits.

One place to buy the stuff: http://tinyurl.com/yq3tvp

Or you can get it for cheap from the outfits mentioned in 3P's excellent write up.

While you have it out cut a gasket for the CPS so you never have to mess with that O ring again. Might as well replace the cover and gasket too...

January 20th, 2008, 01:45 AM
I did it as well. I had to buy the new gear, because I DON'T own a 20 ton press. It was a stone cold bitch to get out, too, if I had to do it again I might just buy a press!

Other than that, it was simple.

October 27th, 2011, 02:15 AM
Thanks for the link for the parts. Have not been able to find 3p's write up.

October 28th, 2011, 11:56 AM
Found this link:


Seems to be broken though, might've gotten shuffled around or is in a different section.

October 28th, 2011, 04:53 PM
I reused the gear without a press. Just drill the original dowel out, and i forget how i got the gear off. Hammer and a vice I think.

November 3rd, 2011, 11:10 AM
Thanx for this. I tried the link too but no..... Out to find a press!

November 3rd, 2011, 11:11 AM
Tried to just punch the dowl but no luck. Press looks like the way to go. $180 at Harbor Freight

November 3rd, 2011, 05:31 PM

November 3rd, 2011, 09:48 PM

November 4th, 2011, 01:06 PM
thanx ya'll. Got it done. The dowl did need to get drilled out. I didn't replace the gear. Came out petty easy. My cover also needed replace. I just used the Jetjock's link and got a complete kit from them. $25. Easy