PDA

View Full Version : Block And Head Measurements



BJ91T
January 16th, 2008, 08:17 AM
I have A 7M here that was machinied quite a long time ago and was neaver run. The engine was given to me and Has a pretty thick MHG in it, I was wondering If there were any "uncut" measurements for a 7m block and head? If so I can measure my cut block and head and figure out why it had a 3mm in it and give me some C/R numbers aswell.



Thanks
BJ

3p141592654
January 16th, 2008, 02:39 PM
Head deck to cam cover flange should be exactly 116mm on an uncut head.

Search around the block and head for numbers stamped in. Most shops will notate the amount they removed using that method.

IJ.
January 16th, 2008, 02:46 PM
The Block was a whole number as well from memory 198mm from deck to Main saddle? (not 100% on this sorry but I did post the spec here somewhere)

BJ91T
January 17th, 2008, 12:22 PM
Thanks for the info guys