PDA

View Full Version : I hate wiring



Xtreme
09-10-2005, 09:42 PM
hey, just put the new head on, and I have a plug that needs a home. It is located coming from the main loom, at about #4 cylinder. Its is a 4 pronged female plug, of which 3 wires are used. Their colors are red, black, and yellow. The plug itself is kinda clear, or maybe was white at one point. Again, it is located coming out of the loom on the drivers side of the engine(with all the fuel injector plugs, on the firewall side of the 3000 pipe. It's not the tps, coil pack, either of the vsvs, the plug that goes under the throttle body, or anything else I can see. It may go under the intake manifold somewhere, it is long enough. Can ya help me?

shaeff
09-10-2005, 10:54 PM
if your car is an automatic, it's most likely for your transmission :)

-shaeff

Xtreme
09-10-2005, 11:00 PM
my car is a manual. I still haven't found it yet.

GrimJack
09-10-2005, 11:52 PM
Pics would help.

There are several plugs that go down between the runners on the intake manifold. Starter, VSV, grounds (2 of them), and 2 plugs to the tranny. And one that isn't used, or at least I haven't found a car that it's used on yet.

Xtreme
09-11-2005, 12:26 AM
It went back towards the tranny, the other end was hiding out of sight, I finally just started tugging on wires to see if any were loose. Thanx for the help. Tomorrow it will run like a new car, yay!

shaeff
09-11-2005, 01:13 AM
just to clear it up, do the wires run to the top of the transmission? if so it's most likely for ABS. (i dont have ABS or an auto tranny, but i'm using an auto tranny wiring harness from a car that also had ABS, and i'm manual, so i just cut off those wires and coated the ends of them to prevent corrosion and electrical shorts)

-shaeff