2JZGE SWAP INTO A CRESSIDA IS IT A DIRECT BOLT IN..???

[2JZMK2+1]

Found a 2jz GE 5speed for a good price an just wanted to know if it can fit into a 89 on CRESSIDA ,,(direct bolt in)

Also how much power can those 2JZ-GE 5speed hold....????

Thx marvin..

[tlo86]

those 2jzgte 5 speed are be W58 their same supra non turbo......

anyways... they say the w58 holds about 300-400 horsepower and i dont think the 2jz is a direct bolt-in with the cressida. search how people bolt the 1jz into the cressida and whatever they do you need to do.

[2JZMK2+1]

those 2jzgte 5 speed are be W58 their same supra non turbo......

anyways... they say the w58 holds about 300-400 horsepower and i dont think the 2jz is a direct bolt-in with the cressida. search how people bolt the 1jz into the cressida and whatever they do you need to do.



Thanx .....Figured it was a W58..... change of plans....lol...

[Nopaint]

no its not a direct bolt in...

[Ken]

you will need motor mount brackets from a JZX81 or JZX90, and if that 2JZGE you're getting has a rear sump oil pan, you will need to swap it out with a front sump pan.

Also if that W58 came out of a MKIV supra, then you're going to have to do something about the shifter. On my friend's cressida we tried swapping out the extension housing from a MK3 W58 but it didn't work out for us, so we ended up using the MK3 W58 transmission with the JZ W58 bellhousing.

[DonS1mpson]

Is the original poster asking about swapping in a 2JZGE with a W58, or just the gearbox?

[2JZMK2+1]

Is the original poster asking about swapping in a 2JZGE with a W58, or just the gearbox?


complete setup motor an trans..... 2JZGE AN W58 TRANNY...

[soapra]

you will need motor mount brackets from a JZX81 or JZX90, and if that 2JZGE you're getting has a rear sump oil pan, you will need to swap it out with a front sump pan.

Also if that W58 came out of a MKIV supra, then you're going to have to do something about the shifter. On my friend's cressida we tried swapping out the extension housing from a MK3 W58 but it didn't work out for us, so we ended up using the MK3 W58 transmission with the JZ W58 bellhousing.


100% Right!

[DonS1mpson]

complete setup motor an trans..... 2JZGE AN W58 TRANNY...

Okay, that's what I thought.

What would have to be done in terms of electronics? I've read in the past that not only is it possible to run a 2JZGE off of the 7MGE ECU and Loom, but it's fairly easy (It's a matter of swapping around a couple of senors to 2JZ ones and getting something to control the fuel, apparently). Any truth behind this?

I have often thought about going 2JZGE as a stop gap for a full blown NA-T setup.

[Jacob]

toyotacressida.net
jzxproject.com