Magnet Isolation Material for Dual Walbros - Where to Buy???

[csnow]

Anyone know what type of material is used to isolate the magnets on a dual walbro setup? Can someone post a link as to where to buy it.

Thanks in advance...

Chris

[Supracentral]

Any fuel or oil resistant rubber will work.

A big diesel truck shop will likely have some hose you can slit and wrap around the pumps.

[Blackfin]

It is just rubber. Don't select anything too thick otherwise it will be very hard to get the pumps in and out of the tank.

The rubber I had was maybe 3/32 inch thick. I had two pieces of rubber but found that if I had two layers between the two pumps, the total width was two much to fit into the tank. This is with almost 1/4 inch of material already removed on each side of the pump access port.

Also, I have a pair of walbros with hanger and -6 fuel hose that I don't need and am going to sell.

[csnow]

Thanks guys..just what I was looking for.

Blackfin....PM sent.

Chris

[porsches4lunch]

Any fuel or oil resistant rubber will work.

A big diesel truck shop will likely have some hose you can slit and wrap around the pumps.

Thank You, Finally!!!!!!!!