Anyone in DFW with 1JZ swap experience ??

[zoonwen]

Just got my motor in today and about to begin my swap, lookin for some help and advice on the wiring harness. :)

[Satan]

Got a couple of us here....where are you located and what have ya got...?

For instance, did your 1J come from a Supra, or Chaser, etc? Also, what car is it going into (pre-89, 89+)?

E

[zoonwen]

I ordered a clip from German, at GS-motorsports but ended up getting a motor set, but it came with motor, tranny, drive shaft, down pipe, harness and ecu, map sensor, ignitor, and p/s resivor.

its goin into an 1986.5 supra, but i already have a pre 89 cross member installed, 2jz throttle cable and p/s line.

I was planning on leaving the wiring harnes on the motor when i extend it but have not started yet.

Not sure how im goin to do the a/c yet, but i'll worry about that later.

[zoonwen]

Were doin the swap at my house in denton, where me and my bro go to school. Its just me and my brother and sisters who live here.

[Satan]

Join us on the Yahoo list.... SW Supras.

Lots of us local Supra guys and lots of experience to assist/help. I was in Denton messing with another Supra, just a couple of weeks ago. Did that engine set come from a JZA70 Supra?

[zoonwen]

Yes it was from a jza70, im tryin to figure out how to wire the ea2 plug, and which ones i need......

[Satan]

http://1jz-gte.us/
www.supras.nl
... and the Yahoo MKIIIJZA70 Yahoo list are great places to start. Much of the figuring out has already been done and documented....