becauseican
01-24-2006, 12:42 AM
I am finally offically releasing my BIC adjustable sway bar end links. I have been testing them on my car for three years and they still work great, look great and dont rattle.
The endlinks use high strength rod ends, and assembled with grade 8 caduim plated hardware. They are adjustable upto 3/4" shorter and 1" longer than stock. The adjustablity is very neccissary when using on an aftermarket sway bar, such as the rear bar of the Suspension Technics swaybar kit. When using the "stiff" hole on the bar the stock end link too short and it pulls the ends of the bar down which puts the link at a sharp angle. The sharp angle leads to binding and possible breakage of the lower mounting tab. (those of you with the ST bars know this already).
I have also developed a weld on reinforcing tab for the rear lower link mount. As stated above, the stock rear lower link mount is prone to breakage when aftermarket sway bars are used. These reinforcements just need about 5 minuites of welding per side to attach. I will include them for only $25 when ordered with a rear end link set. The tab can be seen in the pic of the rear endlink below. It fits on the outside of the factory link mount.
The price for one pair of end links is $115.
The price for two pairs of end links is $220, which is $10 off the regular price when two pairs are ordered
Add $25 for the weld on rear lower reinforcing tabs.
Shipping is $18.
One pair of end links will do one end of the car, two pairs will be needed to do the whole car. I accept paypal and money orders, if you want to order email me at info@bicperformance.com
The endlinks use high strength rod ends, and assembled with grade 8 caduim plated hardware. They are adjustable upto 3/4" shorter and 1" longer than stock. The adjustablity is very neccissary when using on an aftermarket sway bar, such as the rear bar of the Suspension Technics swaybar kit. When using the "stiff" hole on the bar the stock end link too short and it pulls the ends of the bar down which puts the link at a sharp angle. The sharp angle leads to binding and possible breakage of the lower mounting tab. (those of you with the ST bars know this already).
I have also developed a weld on reinforcing tab for the rear lower link mount. As stated above, the stock rear lower link mount is prone to breakage when aftermarket sway bars are used. These reinforcements just need about 5 minuites of welding per side to attach. I will include them for only $25 when ordered with a rear end link set. The tab can be seen in the pic of the rear endlink below. It fits on the outside of the factory link mount.
The price for one pair of end links is $115.
The price for two pairs of end links is $220, which is $10 off the regular price when two pairs are ordered
Add $25 for the weld on rear lower reinforcing tabs.
Shipping is $18.
One pair of end links will do one end of the car, two pairs will be needed to do the whole car. I accept paypal and money orders, if you want to order email me at info@bicperformance.com